Tuesday, October 4, 2011

major fail.

So far my home cooked meals have all involved the following things: grains, noodles, vegetables and chicken. Wanting to expand my horizons a bit, I spontaneously bought a pound of beef chunks for dinner. The results... were not so hot.

With the stove going and the oil popping, I found myself wondering how I was going to transfer the beef to the pan without splattering blood and oil all over the place. Ended up using a fork to throw in each piece individually. Also ended up still splattering blood and oil all over the place.

I then threw the veggies in - way too early apparently, but they were the least of my problems. At this point I was freaking out because the majority of the beef looked overcooked, but 2 pieces didn't look quite done. Not wanting to ruin the meat any further, I turned off the stove and plucked out the odd-ball pieces for closer inspection.


Not okay.

I then proceeded to cut every single chunk in half to make sure they were cooked all the way through. Just as I suspected, most of them were overcooked, so now I'm confused. How does this happen? What did I do wrong? These two pieces weren't much larger than the others and I don't think I was that slow in putting all the food in the pan.


As a minor consolation, the rest tasted fine. 

I think. 

I'm afraid to feed other people.

2 comments:

AIC said...

use long chopsticks and a shield. the medium rare chunks actually look pretty good, but the fobby corningware plate does not...

grace said...

it's your cheapo pan. i'm getting me an all clad set - so you can have my sorta fancy hand-me down set from yassie. yeah why is this format so fancy now??